"SPAD" Simple Plastic Aircraft Design

[KENNYGLIDE]

Dangling the carrot Dave or should i say the sausage... how could i resist an offer like that? ...... Yeah i think it would be a good opportunity to have a chat and get the ball rolling.... as far as tools ect: nothing special required mostly just the usual glue gun, and the other tools we use for the assembly of Balsa Arf and Foamies maybe a Gas blow torch for flashing corflute. , and a little heat for the bending processes.. BUT not required for this first project as I still would prefer to stick with the simple delta wing to start with..... I have some DEPRON ....size 19.5 inches x 27.5 inches which would suit the delta project perfectly.... i will supply these free to those who want to build the delta wing described in the following youtube link.. https://www.youtube.com/watch?v=dDi0Tfj0vIc ........ if some other people can get some tape for the project by Sunday perhaps we can make a start doing the covering,if not i will still bring the DEPRON and we can mark them out and cut to size....... i have enough tape to do my own so maybe a bit of a covering lesson by someone who knows what they are doing.... i would appreciate some replies so i know approximately how many sheets of Depron i will need to supply. For members who would prefer to build something different just bring the plans ,would be good to see what else is out there and maybe look at building them in the future .... HERE'S THE LINK AGAIN FOR THE SIMPLE DELTA WING. https://www.youtube.com/watch?v=dDi0Tfj0vIc