"SPAD" Simple Plastic Aircraft Design

[KENNYGLIDE]

Probably be able to sort out the sizes required from the templates down at the club house anyway ...Thanks anyway Marcel......cutting is going to be awkward at the clubhouse due to not having power....I was thinking , marking the parts out on the corflute at the clubhouse. And then each person takes their ready marked sheets of corflute home and cut them out the best way they know how......doing it at the clubhouse would be very time consuming and difficult i feel.....as there are a lot of pieces.......once cut, bring all the prepared parts back to the clubhouse and we assemble them as a group. The other problem is the glue gun ...we need good , larger and very hot glue guns ......and POWER....These are simply suggestions ....brainstorming. .....please if anyone can come up with other ways to simplify this build .. post them on this forum